Eclipse V6-3.0L SOHC (2003)
The system may be at fail-safe mode as the SWS communication line is defective. If the system can not receive any signal from the column switch
(windshield wiper and washer switch) due to a open circuit in the SWS communication line or other reasons, the system will enter the fail-safe mode
when the ignition switch is at the "ACC" position.
TROUBLESHOOTING HINTS
-
Malfunction of the column switch (windshield wiper and washer switch)
-
Malfunction of the front-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991862: SWS Monitor Kit
Use scan tool to select "ECU COMM CHECK" on the SWS monitor display.
Check the following ECUs:
-
Column-ECU
-
Front-ECU
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502. Also connect SWS Monitor Kit MB991862 after turning on scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS Monitor Kit MB991862 to the column switch connector.
3. Turn the ignition switch to the "ON" position.
4. Operate the MUT-II according to the procedure below to display "ECU COMM CHECK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "ECU COMM CHECK."
5. Scan tool MB991502 should show "OK" on the "ECU COMM CHECK" menu.
Q:Are "OK" displayed on the "COLUMN ECU" and "FRONT ECU" menu?
"OK" are displayed for all the items : Replace the front-ECU.Check that the windshield wiper works normally.
"NG" is displayed on the "COLUMN ECU" menu : "NG" is displayed on the "COLUMN ECU" menu: Refer to Inspection Procedure A-2
"Communication with column switch (column-ECU) is impossible."
"NG" is displayed on the "FRONT ECU" menu : "NG" is displayed on the "FRONT ECU" menu: Refer to Inspection procedure A-4
"Communication with front-ECU is impossible."
