Eclipse V6-3.0L SOHC (2003)
STEP 6. Check the wiring harness between windshield wiper motor connector A-03 (terminal 2) and front-ECU connector A-11X (terminal 23).
NOTE: Also check intermediate connector C-06. If intermediate connectors C-06 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between windshield wiper motor connector A-03 (terminal 2) and front-ECU connector A-11X (terminal 23) in good condition?
YES: Replace the front-ECU. The windshield wiper should stop at the predetermined park position.
NO: Repair the wiring harness. The windshield wiper should stop at the predetermined park position.
Inspection Procedure G-5
Windshield Wiper And Washer: Windshield Intermittent Wiper Interval Can Not Be Adjusted By Means Of Windshield Intermittent Wiper
Interval Adjusting Knob.
NOTE: This troubleshooting requires use of scan tool MB991502 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor."
