Eclipse V6-3.0L SOHC (2003)
STEP 5. Check the harness wires between rear wiper motor connector F-07 (terminal 3) and ETACS-ECU connector C-119 (terminal 16).
NOTE: After checking intermediate connector F-24 and junction block connector C-101, check the wires. If intermediate connector F-24 and junction
block connector C-101 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between rear wiper motor connector F-07 (terminal 3) and ETACS-ECU connector C-119 (terminal 16) in good condition?
YES: Replace the ETACS-ECU. The rear wiper should work normally.
NO: Repair the wiring harness. The rear wiper should work normally.
Inspection Procedure H-2
Rear Wiper And Washer: Rear Wiper Does Not Stop At The Predetermined Park Position.