mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2245 > < Initial Inspection and Diagnostic Overview|Page 2243
Page 181
background image

Q: Does the rear washer motor operate normally?

YES: Go to Step 4.

NO: Replace the rear washer motor. Check that the rear washer works normally.

STEP 4. Check at rear washer motor connector A-34 to check the rear washer motor ground circuit.

1. Disconnect rear washer motor connector A-34, and measure at the wiring harness side.

2. Measure the resistance value between terminal 2 and ground.

-

The measured value should be 2 ohm or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 7.

NO: Go to Step 5.

STEP 5. Check rear washer motor connector A-34 for damage.

Q: Is rear washer motor connector A-34 in good condition?

YES: Go to Step 6.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the rear washer works normally.

Initial Inspection and Diagnostic Overview|Page 2245 > < Initial Inspection and Diagnostic Overview|Page 2243