Eclipse V6-3.0L SOHC (2003)
STEP 5. Check the wiring harness between front-ECU connector A-10X (terminal 5) and the battery.
Q: Is the wiring harness between front-ECU connector A-10X (terminal 5) and the battery in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the tail lights illuminate normally.
Inspection Procedure J-2
Headlight, Tail Light: Headlights (Low-beam) Do Not Illuminate Normally.
NOTE: This troubleshooting requires use of scan tool MB991502 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor."
Headlight Relay (Hi-beam) Circuit
CIRCUIT OPERATION
-
When the lighting switch is set to "HEAD" position, the "HEAD" signal is sent through the column-ECU (incorporated in the column switch) to
the front-ECU. IF the front-ECU receives the "HEAD" signal through the column-ECU, the front-ECU turns on the headlight relay (incorporated
