Eclipse V6-3.0L SOHC (2003)
1. Disconnect front combination light (LH) connector A-26, and measure at the wiring harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 16.
NO: Go to Step 14.
STEP 14. Check front combination light (LH) connector A-26 for damage.
Q: Is front combination light (LH) connector A-26 in good condition?
YES: Go to Step 15.
NO: Repair or replace the connector. Refer to Harness connector Inspection. Check that the position light (LH) illuminates normally.
