Eclipse V6-3.0L SOHC (2003)
Q: Is the wiring harness between rear combination light (RH) connector F-09 (terminal 2) and front-ECU connector A-10X (terminal 8) in good
condition?
YES: Replace the rear combination light socket assembly (RH). Check that the tail light (RH) illuminates normally.
NO: Repair the wiring harness. Check that the tail light (RH) illuminates normally.
STEP 36. Check the rear side marker light bulb (LH).
1. Remove the rear side marker light bulb (LH).
2. Check that the rear side marker light bulb (LH) is not broken.
Q: Is the rear side marker light bulb (LH) in good condition?
YES: Go to Step 37.
NO: Replace the rear side marker light bulb (LH). Check that the rear side marker light (LH) illuminate normally.
STEP 37. Measure at rear side marker light (LH) connector F-20 in order to check the ground circuit to the license plate lights.
1. Disconnect rear side marker light (LH) connector F-20, and measure at the wiring harness side.
2. Measure the resistance value between terminal 1 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
