Eclipse V6-3.0L SOHC (2003)
Q: Is the wiring harness between rear side marker light (RH) connector F-11 (terminal 2) and front-ECU connector A-10X (terminal 8) in good
condition?
YES: Replace the rear side marker light socket (RH). Check that the rear side marker light (RH) illuminate normally.
NO: Repair the wiring harness. Check that the rear side marker light (RH) illuminate normally.
STEP 48. Check the license plate light bulb.
1. Remove the license plate light bulb.
2. Check that the license plate light bulb is not broken.
Q: Is the license plate light bulb in good condition?
YES: Go to Step 49.
NO: Replace the license plate light bulb. Check that the license plate light illuminate normally.
STEP 49. Measure at license plate light connector F-15 in order to check the ground circuit to the license plate lights.
1. Disconnect license plate light connector F-15, and measure at the wiring harness side.
2. Measure the resistance value between terminal 1 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
