Eclipse V6-3.0L SOHC (2003)
1. Connect scan tool MB991502 to the data link connector.
2. Connect SWS monitor kit MB991862 to the column switch connector.
3. Operate the MUT-II according to the procedure below to display "H/L AUTO-CUT."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "FUNCTION DIAGNOSIS"
5. Select "LIGHTING."
6. Select "H/L AUTO-CUT."
4. Check that normal conditions are displayed on the items described in the table.
5. When the driver's door is opened, check that normal conditions are displayed on the items described in the table.
Q: Does the scan tool display the items "TAILLIGHT SW", "IG SW IG1", "FRONT DOOR SW" and "H/L AUTO-CUT" as normal condition?
YES: Replace the front-ECU. Check that the headlight automatic shutdown function works normally.
NO:
-
The scan tool does not show the respective normal condition for item "TAILLIGHT SW." Refer to Inspection Procedure O-7
"ETACS-ECU does not receive a signal from the tail light switch."
-
The scan tool does not show the respective normal condition for item "IG SW (IG1)." Refer to Inspection Procedure O-2 "ETACS-ECU
does not receive a signal from the ignition switch (IG1)."
-
The scan tool does not show the respective normal condition for item "FRONT DOOR SW." Refer to Inspection Procedure O-6
"ETACS-ECU does not receive a signal from the driver's or the front passenger's door switch."
-
The scan tool does not show the respective normal condition for item "H/L AUTO-CUT." Replace the front-ECU. Check that the headlight
automatic shutdown function works normally.
Inspection Procedure J-10
