Eclipse V6-3.0L SOHC (2003)
STEP 6. Check the wiring harness between ETACS-ECU connector C-119 (terminal 11) and the battery.
NOTE: Also check junction block connector C-112 and intermediate connector C-89. If junction block connector C-112 or intermediate connectors
C-89 is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-119 (terminal 11) and the battery in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the turn-signal lights illuminate normally.
STEP 7. Check the input signal by using "FUNCTION DIAGNOSIS" of the SWS monitor.
Check the input signals from the following switches:
-
Ignition switch: ON
-
Turn-signal light switch: RH
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502. Also connect SWS monitor kit MB991862 after turning on scan tool MB991502.
