Eclipse V6-3.0L SOHC (2003)
Q: Which turn-signal light does not illuminate?
front turn-signal light (LH): Go to Step 2.
front turn-signal light (RH): Go to Step 8.
rear combination light (LH): Go to Step 14.
rear combination light (RH): Go to Step 20.
combination meter (LH): Go to Step 26.
combination meter (RH): Go to Step 28.
combination meter (both right and left): Go to Step 30.
LH side only : Refer to Inspection Procedure K-1 Turn-signal lights does not flash when the turn-signal light switch is turned on.
RH side only : Refer to Inspection Procedure K-1 Turn-signal lights does not flash when the turn-signal light switch is turned on.
Both LH and RH sides : Refer to Inspection Procedure K-2 Hazard warning light does not illuminate.
STEP 2. Check the front turn-signal light bulb (LH).
1. Remove the front turn-signal (LH) light bulb.
2. Check that the front turn-signal light bulb (LH) is not broken.
Q: Is the front turn-signal (LH) light bulb in good condition?
YES: Go to Step 3.
NO: Replace the front turn-signal (LH) light bulb. Check that the turn-signal lights illuminate normally.
STEP 3. Measure at front combination light (LH) connector A-26 in order to check the ground circuit to the front combination light (LH).
1. Disconnect front combination light (LH) connector A-26, and measure at the wiring harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
