Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 24.
NO: Go to Step 22.
STEP 22. Check rear combination light (RH) connector F-09 for damage.
Q: Is rear combination light (RH) connector F-09 in good condition?
YES: Go to Step 23.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.
