Eclipse V6-3.0L SOHC (2003)
2. Measure the voltage between terminal 1, 2 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check fog light relay connector A-04X for damage.
Q: Are fog light relay connector A-04X in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the fog lights illuminate normally.
STEP 6. Check the wiring harness between fog light relay connector A-04X (terminals 1 and 2) and the battery.
Q: Is the wiring harness between fog light relay connector A-04X (terminals 1 and 2) and the battery in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the fog lights illuminate normally.