Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 12.
NO: Go to Step 10.
STEP 10. Check fog light (RH) connector A-31 for damage.
Q: Is fog light (RH) connector A-31 in good condition?
YES: Go to Step 11.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the fog lights illuminate normally.
STEP 11. Check the wiring harness between fog light (RH) connector A-31 (terminal 2) and ground.
Q: Is the wiring harness between fog light (RH) connector A-31 (terminal 2) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the fog lights illuminate normally.
