Eclipse V6-3.0L SOHC (2003)
2. The theft-alarm indicator light should illuminate when terminal 74 is grounded.
Q: Does the theft-alarm indicator light illuminate?
YES: Go to Step 10.
NO: Go to Step 3.
STEP 3. Check the theft-alarm indicator light.
Q: Is the theft-alarm indicator light bulb in good condition?
YES: Go to Step 4.
NO: Replace the bulb. The theft-alarm indicator light should illuminate, and the theft-alarm system should be set normally.
STEP 4. Check the combination meter (printed-circuit board).
1. Remove the combination meter.
2. Remove the theft-alarm indicator light bulb. Then measure the resistance value between the bulb terminals.
3. Install the bulb to the combination meter, and then measure the resistance value between connector C-42 terminals 31 and 32. The measured
resistance value should be roughly the same as the value measured in Step (2).
Q: Are these two resistance values extremely different?
YES: Repair or replace the combination meter (printed circuit board). Check that the seat belt warning light illuminates normally.