Eclipse V6-3.0L SOHC (2003)
NO (much the same) : Go to Step 5.
STEP 5. Check at combination meter connector C-42 in order to check the battery power supply line to the theft-alarm indicator light circuit.
1. Disconnect combination meter connector C-42, and check at the wiring harness side.
2. Measure the voltage between terminal 32 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 8.
NO: Go to Step 6.
STEP 6. Check combination meter connector C-42 for damage.
Q: Is combination meter connector C-42 in good condition?
YES: Go to Step 7.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The theft-alarm indicator light should illuminate, and the theft-alarm
system should be set normally.
