Eclipse V6-3.0L SOHC (2003)
STEP 3. Check the wiring harness between ETACS-ECU connector C-119 (terminal 8) and the ignition switch (IG1).
NOTE: Also check junction block connector C-111. If junction block connector C-111 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-119 (terminal 8) and ignition switch (IG1) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the ignition
switch (IG1) should be normal.
Inspection Procedure O-3
The ETACS-ECU Does Not Receive Any Signal From The Fog Light Switch.
