Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 7 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check fog light switch connector C-76 for damage.
Q: Is fog light switch connector C-76 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Repair the fog light switch. If the for light switch operates normally, it
indicates that a correct signal is sent from the fog light switch.