Eclipse V6-3.0L SOHC (2003)
STEP 6. Check the wiring harness between driver's seat belt switch connector D-13 (terminal 1) and ETACS-ECU connector C-117 (terminal
21).
NOTE: Also check intermediate connector C-90. If intermediate connectors C-90 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between driver's seat belt switch connector D-13 (terminal 1) and ETACS-ECU connector C-117 (terminal 21) in good
condition?
YES: Replace the ETACS-ECU. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the driver's
seat belt switch should be normal.
NO: Repair the wiring harness. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the driver's
seat belt switch should be normal.
Inspection Procedure P-4
The ETACS-ECU Does Not Receive Any Signal From The Driver's Or Front Passenger's Door Lock Key Cylinder Switch.