Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 9 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check power window main switch connector E-12 for damage.
Q: Is power window main switch connector E-12 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the central door locking system works normally, input signal from the
door lock switch should be normal.
