Eclipse V6-3.0L SOHC (2003)
STEP 8. Check the door lock switch (power window sub switch).
Remove the power window sub switch.Refer to Door - Door Trim and Waterproof Film. Then check continuity between the switch terminals.
Q: Is the door lock switch (power window sub switch) in good condition?
YES: Go to Step 9.
NO: Replace the power window sub switch. If the central door locking system works normally, input signal from the door lock switch should be
normal.
STEP 9. Measure at power window sub switch connector E-05 in order to check the ground circuit to the power window sub switch.
1. Disconnect power window sub switch connector E-05, and measure at the harness side.
