Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 12.
NO: Go to Step 10.
STEP 10. Check power window sub switch connector E-05 for damage.
Q: Is power window sub switch connector E-05 in good condition?
YES: Go to Step 11.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the central door locking system works normally, input signal from the
door lock switch should be normal.
