Eclipse V6-3.0L SOHC (2003)
1. Do not disconnect rear wiper motor connector F-07.
2. Turn the ignition switch to the "ACC" position.
3. Measure the voltage between terminal 1 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check rear wiper motor connector F-07 for damage.
Q: Is rear wiper motor connector F-07 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the rear wiper operates normally, it indicates that a correct auto-stop
signal is sent from the rear wiper motor.