Eclipse V6-3.0L SOHC (2003)
STEP 7. Check the wiring harness between rear wiper motor connector F-07 (terminal 2) and ETACS-ECU connector C-119 (terminal 17).
NOTE: Also check intermediate connector F'-24 and junction block connector C-101. If intermediate connector F-24 or junction block connector C-101
is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between rear wiper motor connector F-07 (terminal 2) and ETACS-ECU connector C-119 (terminal 17) in good condition?
YES: Replace the ETACS-ECU. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear wiper motor.
NO: Repair the wiring harness. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear wiper motor.
Inspection Procedure P-8
The ETACS-ECU Does Not Receive Any Signal From Hood Switch.
