Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 1 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check hood switch connector A-23 for damage.
Q: Is hood switch connector A-23 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the theft-alarm system operates normally, it indicates that a correct
signal is sent from the hood switch.
STEP 4. Check the wiring harness between hood switch connector A-23 (terminal 1) and ground.
Q: Is the wiring harness between hood switch connector A-23 (terminal 1) and the ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the theft-alarm system operates normally, it indicates that a correct signal is sent from the hood switch.
