mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2564 > < Initial Inspection and Diagnostic Overview|Page 2562
Page 500
background image

Q: Is the wiring harness between ETACS-ECU connector C-118 (terminal 63) and vehicle speed sensor connector B-39 (terminal 3) in good condition?

YES: Replace the ETACS-ECU. If the wiper interval can be adjusted normally, it indicates that the windshield intermittent wiper interval adjusting
knob should send a signal to the ECU.

NO: Repair the wiring harness. If the wiper interval can be adjusted normally, it indicates that the windshield intermittent wiper interval adjusting
knob should send a signal to the ECU.

Inspection Procedure P-12

ETACS-ECU Does Not Receive Vehicle Speed Signal. <A/T>

Vehicles Speed Signal Input Circuit

CIRCUIT OPERATION

The ETACS-ECU controls the windshield intermittent wiper interval according to the vehicle speed signal, which the powertrain control module sends.

Initial Inspection and Diagnostic Overview|Page 2564 > < Initial Inspection and Diagnostic Overview|Page 2562