Eclipse V6-3.0L SOHC (2003)
2. Measure the voltage between terminal 20 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 4.
NO: Go to Step 2.
STEP 2. Check ETACS-ECU connector C-119 for damage.
Q: Is ETACS-ECU connector C-119 in good condition?
YES: Go to Step 3.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the functions or equipment, which are described in "CIRCUIT
OPERATION", work normally, the interior light loaded signal should be normal.
