Eclipse V6-3.0L SOHC (2003)
STEP 6. Check the wiring harness between ETACS-ECU connector C-119 (terminal 8) and the ignition switch (IG1).
NOTE: Also check junction block connector C-111. If junction block connector C-111 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-119 (terminal 8) and the ignition switch (IG1) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the functions or equipment, which are described in "CIRCUIT OPERATION", work normally, the interior light
loaded signal should be normal.
STEP 7. Measure at ETACS-ECU connector C-I 19 in order to check the ignition switch (ACC) line of the power supply to the ETACS-ECU.
1. Disconnect ETACS-ECU connector C-119, and measure at the junction block side.
2. Turn the ignition switch to the "ACC" position.
3. Measure the voltage between terminal 4 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 10.
NO: Go to Step 8.
