Eclipse V6-3.0L SOHC (2003)
YES: No action to be taken.
NO: Repair the wiring harness. If the functions or equipment, which are described in "CIRCUIT OPERATION", work normally, the interior light
loaded signal should be normal.
STEP 10. Measure at ETACS-ECU connector C-119 in order to check the ignition switch (ACC) line of the power supply to the ETACS-ECU.
1. Disconnect ETACS-ECU connector C-119, and measure at the junction block side.
2. Turn the ignition switch to the "ACC" position.
3. Measure the voltage between terminal 18 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Replace the ETACS-ECU. If the functions or equipment, which are described in "CIRCUIT OPERATION", work normally, the
interior light loaded signal should be normal.
NO: Go to Step 11.
STEP 11. Check ETACS-ECU connector C-119 for damage.
Q: Is ETACS-ECU connector C-119 in good condition?
YES: Go to Step 12.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the functions or equipment, which are described in "CIRCUIT
