Eclipse V6-3.0L SOHC (2003)
Fuel Injector: Service and Repair
REMOVAL AND INSTALLATION
Injector
REMOVAL SERVICE POINT
<<A>> FUEL RAIL/INJECTORS REMOVAL
CAUTION: Do not drop the injector.
Remove the fuel rail with the injectors attached to it.
INSTALLATION SERVICE POINT
>>A<< INJECTORS/FUEL PRESSURE REGULATOR/HIGH-PRESSURE FUEL HOSE INSTALLATION
CAUTION: Do not allow the engine oil to enter the fuel rail, otherwise it will be damaged.
1. Apply a drop of new engine oil to the O-ring.
2. Turn the injector. To the right and left to install to the fuel rail. Repeat for fuel pressure regulator and high-pressure fuel hose.
Be careful not to damage the O-ring. After installing, check that the item turns smoothly.
3. If it dose not turn smoothly, the O-ring may be trapped, remove the item, re-install it into the fuel rail and check again.
4. Tighten the fuel pressure regulator and high-pressure fuel hose to the specified torque.
Tightening torque:
8.8 ± 1.0 N.m (78 ± 9 in-lb) <Fuel pressure regulator>
