Eclipse V6-3.0L SOHC (2003)
Use special tool MB991120 to remove the needle roller bearing from the rack housing.
<<K>> OIL SEAL REMOVAL
CAUTION: Be careful not to damage the inner surface of the rack cylinder of the gear housing.
Use a piece of pipe or similar tool to remove the oil seal from the gear housing.
ASSEMBLY SERVICE POINTS
>>A<< OIL SEAL INSTALLATION
1. Apply a coating of GENUINE MITSUBISHI POWER STEERING FLUID to the both sides of the oil seal.
2. Using special tools MB991199 and MB991197 press the oil seal into the rack housing.
>>B<< NEEDLE ROLLER BEARING/BALL BEARING INSTALLATION
1. Apply GENUINE MITSUBISHI POWER STEERING FLUID to housing bearing and oil seal press fitting surface.
CAUTION: Press-fit straight. The valve housing is aluminum and may become deformed if press-fit on an angle.
2. Press fit needle roller bearing with special tools MB990938 and MB991202.
>>C<< OIL SEAL/O-RING INSTALLATION
