Eclipse FWD L4-1997cc 2.0L DOHC MFI (1997)
<B> CLIP REMOVAL
1. Use a Phillips-head screwdriver to push inward the pin (at the center of the clip) to a depth of about 2 mm (0.08 in.).
2. Pull the clip outward to remove it.
CAUTION: Do not push the pin inward more than necessary because it may damage the grommet or the pin may fall in, if pushed too far.
<C> HEATER UNIT REMOVAL
After sliding the cooling unit towards you slightly, remove the heater unit.
INSTALLATION SERVICE POINT
>A< CLIP INSTALLATION
1. With the pin pulled out, insert the clip into the hole.
2. Push the pin inward until the pin's head is flush with the grommet.
