mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Steering - Drift Diagnosis And Correction.|Page 578 > < Steering - Drift Diagnosis And Correction.|Page 576
Page 4
background image

On offset lower compression arms, the mounting holes in the rear bushing are off-center as shown.

IMPORTANT:

Refer to the diagnosis chart. Perform all applicable steps of this procedure in the order described. When test driving, the road surface should be dry
and level. Avoid test drives in windy conditions.

1.

Check the tire inflation pressures. On affected vehicles, cold tire inflation pressure specifications are 32 psi (front), and 29 psi (rear). Adjust tire
inflation pressures as needed.

2.

Check the wheel alignment of the vehicle. Refer to section 33A of the appropriate service manual for specifications. Adjust wheel alignment as
needed.

3.

Test drive the vehicle at highway speeds.

^

If steering drift is not observed, return the vehicle to the customer.

^

If steering drift is observed, go to Step 4.

4.

Cross-switch the front tires. Then test drive the vehicle again at highway speeds.

^

If steering drift is not detected, return the vehicle to the customer.

^

If steering drift is observed, continue with Step 5.

5.

a. If steering drift is to the left, replace the front suspension lower compression arms. Refer to the PARTS INFORMATION section of this

bulletin for part numbers. Refer to section 33 in the appropriate service manual for replacement instructions. Then continue with Step 7.

Steering - Drift Diagnosis And Correction.|Page 578 > < Steering - Drift Diagnosis And Correction.|Page 576