Eclipse FWD L4-1997cc 2.0L DOHC MFI (1997)
If the power steering pulley is out of alignment, use the following procedures to shim the power steering pump into proper alignment.
1.
Remove the bolt holding the power steering pump bracket to the front area of the engine mount. Loosen the remaining two bolts attaching the
power steering pump bracket.
2.
Add the necessary number of 1 mm shims between the pump bracket and the front engine mount so the pump is moved to where the pulley is in
alignment.
Note:
FOR BETTER PULLEY ALIGNMENT ON VEHICLES WITH AIR CONDITIONING:
a.
Move the power steering pump closer to the engine (along the adjuster slot in the power steering bracket) then tighten the upper attachment
bolt.
b.
Tighten the two lower power steering pump bolts, last.
c.
Adjust the power steering belt tension by using the idler tension pulley.
3.
Go back to the diagnosis procedures to check the belt alignment again before returning the vehicle to the customer.
PARTS INFORMATION
Part Number
Description
Remarks
MA111832
Brake Fluid Line Gasket (use as 1 mm shim)
As required
M04668223
Power Steering Belt
Without A/C
MB878687
Power Steering Belt
With A/C
WARRANTY INFORMATION
R & R and shimming of Power Steering Pump Bracket
Nature Code: 86Z
Cause Code: 490
Labor Operation No.37501000
Time Allowance: 0.8 hr.
Warranty Coverage: 36 months/36,000 miles.
Special Warranty Information:Normal warranty procedures apply.