Eclipse FWD L4-1997cc 2.0L DOHC MFI (1997)
6.
Observe the amount of clean ATF output in 20 seconds. Turn off the engine.
a. If less than one quart of fluid is output in 20 seconds, there may be a restriction in the oil cooler(s). Perform Steps 7 through 9.
b. If one quart or more of fluid is output in 20 seconds, go to Step 10.
7.
Empty the graduated container. Disconnect the inlet line to the oil cooler and place the line in the empty container.
8.
With the inlet line from the oil cooler placed in the container, start the engine in Neutral and watch for clean ATF flow (no bubbles or foam).
Continue until the ATF flows clean and the fluid level reaches the 1-quart mark. Then start the timer for the flow test.
9.
Observe the amount of clean ATF output in 20 seconds. Turn off the engine.
a.
If less than one quart of fluid is output in 20 seconds, replace the transmission. Then repeat Steps 2 through 6 to verify there is no restriction
in the oil cooler(s).
b.
If one quart or more of fluid is output in 20 seconds, replace the radiator. Then continue with Step 10.
IMPORTANT:
On models equipped with an auxiliary oil cooler, remove the line to the auxiliary oil cooler from the radiator and repeat Steps 2 through 4 for flow
testing.
10.
Reconnect the cooler line and fill the transaxle to the proper level. Check fluid level with the transmission in the Neutral position at normal
operating temperature. (Checking the ATF level in Park may give an incorrect fluid level reading.) Inspect and repair any leaks as necessary.
WARRANTY INFORMATION
Every automatic transmission replacement or major transmission repair (e.g., torque converter or valve body replacement) must have both a back flush
and a flow test performed The flow test must be documented and the test results retained in the vehicle file.
The flow test results must also be recorded in the related warranty claim's "Condition, Cause and Remedy" section.
IMPORTANT:
Warranty claims for A" replacements or major transmission repairs (e.g., torque converter or valve body replacement) where a backflush procedure
and a documented flow test were not performed are subject to debit action.
