Eclipse FWD L4-1997cc 2.0L DOHC MFI (1997)
13. Using bench fixture and shims provided (MB995023, MB995024, MB995025 or equivalents), turn transaxle over. Install transaxle onto bench
fixture. Verify shim spacers are in position on bench fixture. Install transaxle into shop press.
14. Install bearing fixture (MB995056 or equivalent) onto transaxle end bearings. Verify tool is properly aligned to input and output shaft.
CAUTION: The oil dams in the input and output shaft can be damaged while pressing on the shafts if the bearing fixture is not properly used.
15. Install transaxle gear case and bench fixture onto shop press. Press output and input shaft assemblies out of case.
16. Remove transaxle from press.
17. Carefully remove transaxle case from the shaft assemblies and bench fixture.
