Eclipse FWD L4-1997cc 2.0L DOHC MFI (1997)
9. Remove blocking ring. Remove 3/4 synchronizer hub retaining snap ring.
10. Install input shaft in shop press. Using MD998801 to remove 3/4 synchronizer and 3rd gear.
11. Remove 3rd gear caged needle bearing. Check the caged needle bearing for a broken retention spring.
12. Inspect the input shaft for worn or damaged bearing races or chipped gear teeth. Replace as necessary.
ASSEMBLY
NOTE: The snap rings that are used on the input shaft are available in select fit sizes. Use the thickness snap ring that will fit in each snap ring
groove.
1. Place input shaft into shop press.
2. Install 3rd gear caged needle bearing on input shaft.
