Eclipse FWD L4-1997cc 2.0L DOHC MFI (1997)
10.
Remove the nuts (2) which attach the bottom of the glass to the regulator mechanism. Pull the regulator bracket out slightly then slide it so you can
access each of the two mounting stud assemblies. Tighten each inner nut on the mounting studs, then reattach the regulator bracket to the window.
Make sure each nut is tight.
11.
Check all upstops, glass, and regulator mounting points for tightness and tighten if necessary.
12.
Test drive the vehicle over the original test course to confirm repair. If the condition is eliminated, go to step 15.
13.
If the problem still occurs, adjust glass slightly down or slightly outward in order to reduce the amount of pressure being applied on the glass by
the A-pillar.
NOTE:
Be very careful when adjusting the glass. Misadjustment may cause wind or water leaks. Make sure the window operates properly with doors
opened or closed.
14.
Test drive vehicle to confirm repair.
15.
Reinstall the speaker, speaker housing, and door trim panel.
16.
Repeat procedure for the other side if necessary.
PARTS INFORMATION
None required.
WARRANTY INFORMATION
