Eclipse GS-T L4-1997cc 2.0L DOHC Turbo MFI (1998)
GREASE POINTS
INSTALLATION
Installation in reverse order as removal.
Installation Service Points
Install Vacuum Hose
>A< Vacuum Hose Connection.
1) Install the vacuum hose to the brake booster nipple as shown in the figure. Secure the hose with the hose clip.
CAUTION:
1. The check valve and the pipe part of the brake booster must not contact each other.
2. Connect so that the marking faces upwards.
2) Install the other end of the vacuum hose fully onto its port on the engine. Secure the hose using the hose clip.
>B< Clearance Adjustment Between Brake Booster Push Rod And Primary Piston.
1) Attach the special tool to the master cylinder.
2) Place the shaft of the special tool gently against the piston of the master cylinder.
3) Turn the wing bolt to secure the shaft.
