Eclipse GS L4-2350cc 2.4L SOHC MFI (2002)
STEP 13. Check the wiring harness between front combination light (RH) connector A-32 and ETACS-ECU connector C-119.
NOTE: Also check junction block connector C-112 and intermediate connector C-94. If junction block connector C-112 or intermediate connector C-94
is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between front combination light (RH) connector A-32 and ETACS-ECU connector C-119 in good condition?
YES: Replace the front combination light socket (RH). Check that the turn-signal lights illuminate normally.
NO: Repair the wiring harness. Check that the turn-signal lights illuminate normally.
STEP 14. Check the rear turn-signal light bulb (LH).
1. Remove the rear turn-signal (LH) light bulb.
2. Check that the rear turn-signal light bulb (LH) is not broken.
Q: Is the rear turn-signal (LH) light bulb in good condition?
YES: Go to Step 15.
NO: Replace the rear turn-signal (LH) light bulb. Check that the turn-signal lights illuminate normally.
STEP 15. Measure at rear combination light (LH) connector F-17 in order to check the ground circuit to the rear combination light (LH).
1. Disconnect rear combination light (LH) connector F-17, and measure at the wiring harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 18.
NO: Go to Step 16.
