Eclipse GT V6-3.0L SOHC (2000)
STEP 4. Check the headlight relay (low) power supply circuit at the headlight relay (low) connector A-08X.
1. Disconnect the headlight relay (low) connector A-08X and measure at the relay box side.
2. Voltage between terminal 4 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
3. Voltage between terminal 3 and ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If one of the measurements above does not show approximately 12 volts, go to Step 5.
If both of the measurements above show approximately 12 volts, go to Step 7.
STEP 5. Check the headlight relay (low) connector A-08X for damage.
If the headlight relay (low) connector A-08X is damaged, repair or replace it. Refer to Harness Connector Inspection.
The headlights (low-beam) should illuminate.
If the connector is in good condition, go to Step 6.
STEP 6. Check the harness wire between headlight relay (low) connector A-08X and battery.
If the harness wire between headlight relay (low) connector A-08X and battery is damaged, repair it.
The low-beam headlights should illuminate.
