Eclipse GT V6-3.0L SOHC (2000)
STEP 2. Check the column switch connector C-86 and ETACS-ECU connector C-111 for damage.
If the column switch connector C-86 and ETACS-ECU connector C-111 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Check that the input signal from the windshield intermittent wiper interval adjusting knob can be checked and the wiper interval can be adjusted.
If the connectors are in good condition, go to Step 3.
STEP 3. Check the harness wire between column switch connector C-86 and ETACS-ECU connector C-111.
If the harness wire between column switch connector C-86 and ETACS-ECU connector C-111 is damaged, repair it. Check that the input signal from the
windshield intermittent wiper interval adjusting knob can be checked and the wiper interval can be adjusted.
If the harness wire is in good condition, replace the ETACS-ECU or column switch.
Check that the input signal from the windshield intermittent wiper interval adjusting knob can be checked and the wiper interval can be adjusted.
Inspection Procedure O-20
Sunroof switch:
-
The "CLOSE/TILT-DOWN" switch signal is not sent to the ETACS-ECU.
-
The "TILT-UP" switch signal is not sent to the ETACS-ECU. The "OPEN" switch signal is not sent to the ETACS-ECU.