Eclipse GT V6-3.0L SOHC (2000)
For spark plug replacement, normal warranty procedures apply.
Procedure
CAUTION
BATTERY VOLTAGE (AS MEASURED AT THE BATTERY POSTS WITHOUT ELECTRICAL LOAD) MUST BE 12.4V OR HIGHER
IN ORDER TO REPROGRAM THE PCM.
1.
Check the underside of the hood to verify that there is no label to indicate that this TSB reprogramming has already been done.
2.
Verify that the vehicle's PCM part number is listed in the table in Attachment A of this bulletin.
a.
Verify whether the ROM ID is the same as the ROM ID listed in the table in Attachment A. If the ROM ID is the same as or higher than the
ROM ID in the table, the PCM has already been reprogrammed for this concern.
3.
Use the MUT-III to erase all DTCs set in the PCM.
4.
Verify that your MUT-III has the most current version of the reprogramming database:
a.
Select "Special Function", then select "ECU Reprogramming."
b.
Select "Database File Display". The database version is displayed in the top right corner of the screen. Make sure the database version is
N05021 or greater.
c.
If the database version is less than N05021, go to Step 5
d.
If the database version is N05021 or greater, go to Step 8.
5.
Turn the ignition key to OFF and disconnect the MUT-III.
6.
Gather the following reprogramming equipment:
-
MUT-III/STV Reflash Update CD 3/05 or later
-
Memory Card 128 MByte Compact Flash MB991853
-
Memory Card Adapter PCMCIA MB991939
-
"Engine Compartment/Control Module" Labels p/n MSSF-024G-00
7.
Install Reflash Update CD 3/05 in the MUT-III LAPTOP. Follow the CD installation instructions.
8.
Transfer the reprogramming data from the LAPTOP to the memory card.
