mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 4785 > < Initial Inspection and Diagnostic Overview|Page 4783
Page 2
background image

Connectors

CIRCUIT OPERATION

The multi-center display is energized by the battery through the ignition switch (ACC) and (IG1).

TECHNICAL DESCRIPTION (COMMENT)

The ground circuit, the battery circuit, the ignition switch (ACC) circuit or the ignition switch (IG1) circuit is suspected to be open or defective.

TROUBLESHOOTING HINTS

-

Malfunction of the multi-center display

-

Damaged harness wires and connectors

DIAGNOSIS

Required Special Tool:

-

MB991223: Harness Set

STEP 1. Check the multi-center display ground circuital the multi-center display connector C-09 by backprobing.

1. Do not disconnect the multi-center display connector C-09 and measure at the harness side.

2. Measure the resistance between terminal 6 and ground by backprobing. 

Q: Is the resistance value less than two ohm

YES: Go to Step 4.

NO: Go to Step 2.

Initial Inspection and Diagnostic Overview|Page 4785 > < Initial Inspection and Diagnostic Overview|Page 4783