Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 9. Check the harness wires between C-09 and ignition switch (ACC).
NOTE: After checking joint connector C-78 and junction block connector C-108 and C-111, check the wires. If joint connector C-78 and junction block
connector C-108 and C-111 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Is the harness wires between C-09 and ignition switch (ACC) in good condition?
YES: There is no action to be taken.
NO: Repair them. The multi-center display should work normally.
STEP 10. Check the multi-center display power supply circuit [ignition switch (IG1)] at the multi-center display connector C-09 by
backprobing.
1. Do not disconnect the multi-center display connector C-09 and measure at the harness side by backprobing.
2. Turn the ignition switch to "ON" position.
3. Measure the voltage between terminal 2 and ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive voltage).
