Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 3. Check the compass-ECU connector C-37 and multi-center display connector C-09 for damage.
Q: Are the compass-ECU connector C-37 and multi-center display connector C-09 in good condition?
YES: Go to Step 4.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 4. Check the compass-ECU connector C-37 and multi center display connector C-09 by backprobing.
1. Do not disconnect the compass-ECU connector C-37 and multi-center display connector C-09, measure at the harness side.
2. Measure the resistance between compass-ECU connector C-37 and multi-center display connector C-09 by backprobing.
Q: Is the resistance value less than two ohm?
YES: Replace the compass-ECU or compass sensor.
NO: Repair or replace it. Refer to Harness Connector Inspection.
03 - Inspection Procedure
The Compass is not Correct
