mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 4795 > < Initial Inspection and Diagnostic Overview|Page 4793
Page 12
background image

STEP 1. Check the vehicle location

 
Q: Are there any constructions, such as high-voltage wires or a steel bridge, which might affect the compass sensor?

YES: After moving to a location where the magnetic field is stable, check the faulty condition again.

NO: Go to Step 2.

STEP 2. Correct magnetization

Q: Was magnetization corrected?

YES: Go to Step 3.

NO: Correct magnetization.

STEP 3. Correct magnetic declination

Q: Was magnetic declination corrected?

YES: Go to Step 4.

NO: Correct the magnetic declination.

STEP 4. Demagnetize

Q: Was that demagnetized?

YES: Replace the compass sensor.

NO: Demagnetize it.

04 - Inspection Procedure

The Ambient Temperature Screen Displayed "E °F" (Ambient Sensor Open Circuit) or "-E5 °F" (Ambient Sensor Short Circuit) These are
Error Message.

Initial Inspection and Diagnostic Overview|Page 4795 > < Initial Inspection and Diagnostic Overview|Page 4793