Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
Gently rotate it over the top of the "tab" in the guide rail. Continue pushing rearward, and remove it from the guide rail.
11.
Remove the drive cable assembly from the rail. Disconnect and remove the old drive cable.
INSTALLING THE NEW DRIVE CABLE ASSEMBLY
Note the original location and position of all parts associated with the drive cable assembly.
The sunroof will not operate properly if the drive cable assembly is not correctly installed.
12.
Thoroughly clean the sunroof rails of all grease, dirt, and foreign material.
13.
Apply Sunroof Grease (listed in the PARTS INFORMATION section of this bulletin) to the top and underside of the housing rail on both sides in
the areas shown.
-->
Apply 1 oz. (approx. 1/2 tube) of Sunroof Grease per vehicle.
CAUTION
Use only the Sunroof Grease listed in this bulletin, or judder could result.
a.
Also apply a uniform coating of Sunroof Grease to the length of the new drive cable.
14.
Install the new drive cable. Leave the drive cable extended approximately 6 inches from the rail.
15.
Place the new lift mechanism in the tilt-up position. The lift link guide roller must be positioned at the top front of ramp of the lift link shoe.
