Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
27.
Reinstall the sunroof motor. Be sure the gear teeth are properly mated. Tighten the bolts alternately. Final torque is 5.4 +/- 1.5 Nm (48 +/- 13
in/lb).
28.
Reinstall the sunroof assembly into the vehicle, leaving the attaching hardware loose to allow for adjustment. Refer to Group 42 in the Eclipse
service manual.
29.
Verify that the side-b-side alignment does not vary more than 2 mm:
On the left and right sides of the vehicle, measure from the edge of the body (sunroof opening) to the inner edge of the silver sunroof housing, at
the front and back as shown. The front left and front right measurements should be as nearly equal as possible (maximum 2 mm variation). The
rear left and rear right measurements should also be as nearly equal as possible (maximum 2 mm variation).
30.
Install the sunroof glass. Adjust the glass height to be flush with the vehicle roof. Be sure the glass front-to-back and left-to-right clearances are
nearly equal. If they are not, adjust the glass to achieve proper clearance. If the clearances cannot be adjusted to be nearly equal, loosen the six
nuts securing the sunroof to the body, and move the sunroof assembly slightly to achieve proper clearance. Retighten the nuts after adjustment.
31.
Check sunroof operation. If the sunroof does not operate properly, perform Step 1 this bulletin. Recheck sunroof operation. If still not operating
properly, remove the sunroof from the vehicle, remove the motor, and readjust the timing as described in Step 22. Then repeat Steps 27 through
30.
32.
Reinstall the headliner. Refer to Group 52 in the Eclipse service manual.
