mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Sunroof - Judder/Vibration During Operation|Page 5207 > < Sunroof - Judder/Vibration During Operation|Page 5198
Page 1
background image

Technical Service Bulletin # 02-42A-005

Date: 020301

Sunroof - Judder/Vibration During Operation

No.: TSB-02-42A-005 
DATE: March, 2002
MODEL: 2000-02 Eclipse

SUBJECT:
SUNROOF JUDDER

PURPOSE

On some affected vehicles, the sunroof may judder or vibrate during opening/closing operation. In some cases, it may be necessary to replace the drive
cable assemblies. This bulletin describes how to install the new, improved drive cable assemblies. The new drive cable assemblies have improved shoes
to decrease sliding friction. Replacement parts with the improved shoes have a date code mark of 8/13/01 or later. Refer to the PARTS INFORMATION
section of this bulletin for how to identify the new shoes.

Do not order a new sunroof assembly to eliminate judder.

Also refer to MMSA Service Video # 82, CD-R 2000-42A-002 for these procedures, except be sure to clean the sunroof rails and apply sunroof grease
before installing the drive cables.

AFFECTED VEHICLES

2000-2002 Eclipse models equipped with sunroof produced before 7/16/01

PARTS INFORMATION

WARRANTY INFORMATION

Sunroof Drive Cable Assembly Replacement

Nature Code: 99D

Cause Code: 990

Labor Operation No. 42366597

Time Allowance: 2.0 hr. (both sides)

Warranty Coverage: 36 months/36,000 miles

Special Warranty Information: Normal warranty procedures apply.

Procedure

1.

If the sunroof cannot be closed completely, reset the sunroof motor timing as follows:

a.

With the sunroof open, press and hold the switch closed. If the sunroof stops, press the switch again and continue to hold it.

b.

When the sunroof reaches the closed position, continue to hold the switch closed for 15 to 30 seconds. This will reset the timing of the

Sunroof - Judder/Vibration During Operation|Page 5207 > < Sunroof - Judder/Vibration During Operation|Page 5198